SWITCH YOUR LIGHT cord switch install tutorial

Recently I added corded switches

to my two wall scones.

Vintage rose revamp can be found here

crystal and rose wall scones.

Ive done this many times before however this time

I noticed there was no instructions on the switch

packaging, so I thought I would share.

The items I bought were a

15ft extension cord and a cord switch.

The tools I used were

phillips screw driver, wire cutters & wire strippers

 

First I cut the outlet end of the cord.

This is the end that was connected to the wall

scones. An additional post explaining this step

will be coming soon.

Second I figured out the location I wanted the

 switch and cut half way thru the cord.

Next was to pull the one side of the cord away

from the other before stripping the cut ends and

twist the exposed wire clockwise.

If you notice in the photos there is a small

amount of the cord cut out completely.

I hooked the two exposed ends to fit onto

the screws in my switch.

Time for the switch.

With my screw driver I remove the cover.

I loosened the screws inside the switch so I

 could hook the wires onto them,

once I had the wire ends in

 place I tighten the screws back down.

Almost done.

I had to push the two wires into the cut out

on each end of the switch housing.

See how everything is in place now.

Lastly I grabbed the cover plate and

screwed it back on to the housing.

Voila there is my new switch,

now to the second one.

There are other kinds and sizes of switches you can

 buy. They may have a different install method also.

 I like these larger ones because they have a

convenient flip switch rather then that turney

 one with teeth that hurt your thumb or finger if too stiff.

You can find other tutorials here.

Ive shared this information at:

Related Posts by Categories